Connection part and connection method of worm drive hose clamps stainless steel
Time of Release：
2021-12-10
Worm drive hose clamps stainless steel is a connecting device for connecting grooved pipe fittings, valves and pipeline fittings. It is used to tighten the quick couplings. Generally, the two couplings are equipped with gaskets, rubber, silicone and Tetrafluoroethylene.
Worm drive hose clamps stainless steel is a connecting device for connecting grooved pipe fittings, valves and pipeline fittings. It is used to tighten the quick couplings. Generally, the two couplings are equipped with gaskets, rubber, silicone and Tetrafluoroethylene. Its performance is good, the sealing degree is high, and the installation is easy. So what connection parts and connection methods are it made of?
worm drive hose clamps stainless steel The groove connecting pipes that play the role of connecting and sealing are mainly composed of three parts: sealing rubber ring, worm drive hose clamps stainless steel and locking bolts.
worm drive hose clamps stainless steel The rubber seal ring located on the inner layer is placed on the outside of the connected pipe and fits with the pre-rolled groove. Then buckle the worm drive hose clamps stainless steel on the outside of the rubber ring, and then use two Just tighten the bolts. Because the worm drive hose clamps stainless steel rubber sealing ring and the worm drive hose clamps stainless steel adopt a unique sealable structure design, the groove connector has a good sealing performance, and as the fluid pressure in the pipe increases, its sealing performance is correspondingly enhanced .
Introduction to the connection method of worm drive hose clamps stainless steel
1. Use a pipe cutter to cut the steel pipe to the required length. Use a level to check the cut section to ensure that the cut section is perpendicular to the central axis of the steel pipe. If the cut has burrs, it should be smoothed with a grinder.
2. The worm drive hose clamps stainless steel fits the steel pipe processing end section close to the roll groove machine, so that the steel pipe's central axis is perpendicular to the roller surface.
3. worm drive hose clamps stainless steel erect the steel pipe to be grooved on the rolling groover and the tailstock of the rolling groover, and level it with a level to make the steel pipe in a horizontal position.
4. Slowly press down. With the jack, make the upper pressing wheel close to the steel pipe, start the rolling groover to make the roller turn one round, at this time pay attention to observe whether the section of the steel pipe is still tightly attached to the rolling groover, if it is not tight, adjust the pipe to the level. If it is tight, press down the jack slowly, so that the upper pressure roller will evenly roll the steel pipe to the predetermined groove depth.
Today, the connection part and connection method of worm drive hose clamps stainless steel are introduced here.
关键词：
Cheap,worm,drive,hose,clamps,stainless,steel,supplier(s),china,Wholesale,worm,drive,hose,clamps,stainless,steel,factory
Tianjin nuocheng hoop Co. Ltd.
E-mail：tjnuocheng@126.com
Tel： +86 13702098855
Fax：022-68781788
Add：Yuanmengkou Industrial Park, Yanzhuang Town, Jinghai County, Tianjin
Copyright © 2022 Tianjin nuocheng hoop Co. Ltd.