Explain the installation and use of Rubber Hose Clamp Assemble on the welding plate Before assembling, in order to better determine the direction of the clamp, it is recommended to mark the fixing place first, then weld it, insert the lower part of the pipe clamp body, and put the pipe to be fixed. Put on the other half of the pipe clamp body and cover plate, and tighten them with screws.

 Never directly weld the bottom plate with the Rubber Hose Clamp installed. To On the ground rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn it 90 degrees, insert the lower half of the pipe clamp body into the nut, put the pipe to be fixed, and then put it The upper half of the pipe clamp body and the cover plate are fixed with screws. To Fold up the assembly, the guide rail can be welded on the foundation of the high pole lamp, or fixed with screws. First install the upper and lower half of the tube clamp body, put the tube to be fixed, and then put the upper half of the tube clamp body, fix it with screws, and pass the protection Loosen the cover to prevent it from turning. Then install the next pipe clamp in the same way as above. 
To When assembling the elbow, it should be fixed directly at the front and back of the elbow with Caster pipe clamps. It is recommended that such a support point should be a fixed position. 1. Application range of Rubber Hose Clamp: Light series pipe clamps are used for ordinary mechanical pressure pipes of 6 sizes series, the outer diameter of the pipe is 6-57mm. Duplex series pipe clamps are used for mechanical pressure pipes of 5 sizes series, the outer diameter of the pipe is 6-42mm. The heavy-duty series of pipe clamps are used in 8 series of high mechanical pressure pipes, the outer diameter of the pipe is 8-273mm. 2. Pipe clamp material characteristic density, bending strength, impact toughness, compressive strength, elastic modulus, tensile strength, temperature resistance, color 3. Pipe clamp installation procedure is assembled on the welding plate before assembly, in order to better determine the clamp For the direction, it is recommended to mark the fixing place first, then weld it, insert the lower part of the pipe clamp body, and put the pipe to be fixed. Put on the other half of the pipe clamp body and cover plate, and tighten them with screws. 
Never directly weld the bottom plate with the Rubber Hose Clamp installed. On the ground rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn it 90 degrees, insert the lower half of the pipe clamp body into the nut, put the pipe to be fixed, and then put it The upper half of the pipe clamp body and the cover plate are fixed with screws. 
Fold up assembly, the guide rail can be welded on the foundation, or fixed with screws, first install the upper and lower half of the Rubber Hose Clamp body, put the pipe to be fixed, and then put the upper half of the pipe clamp body, fixed with screws, through the anti-loosening cover plate Prevent it from turning. Then install the next pipe clamp in the same way as above. Assembling the elbow, when assembling the elbow, it should be fixed directly at the front and back of the elbow. 
It is recommended that such a support point should be a fixed position. Rubber Hose Clamp setting: In order to better determine the direction of the front part of the pipe clamping plate assembled by welding, it is recommended to mark the fixed part, and then weld the pipe clamp body to be inserted into the lower part of the pipe to be placed fixed. Place the pipe clamp body and the protective half on the other side, and tighten them with screws. Do not directly weld the board with the pipe clamp installed.